![]() ![]() Nov 30 20:10:19 raspberrypi systemd: rvice: Service hold-off time over, scheduling restart. Nov 30 20:10:14 raspberrypi systemd: rvice: Failed with result 'exit-code'. Nov 30 20:10:14 raspberrypi systemd: rvice: Unit entered failed state. Process: 4777 ExecStartPre=/bin/sh -c /usr/bin/test -d "$" || /bin/mkdir. Process: 4781 ExecStart=/bin/sh -c LD_LIBRARY_PATH=/usr/lib/plexmediaserver "/usr/lib/plexmediaserver/Plex Media Serv Loaded: loaded (/lib/systemd/system/rvice enabled vendor preset: enabled)Īctive: failed (Result: exit-code) since Thu 20:10:19 UTC 3min 42s ago Here is the print out of the status $ sudo service plexmediaserver status I am running the latest Raspbian Stretch on the Pi. It seems to be installing ok and does not give any error messages after sudo service plexmediaserver start, I just get no webif when I put the IP and port into my web browser. I have followed this guide and looked at others that look the same and can't see what the issue is. ![]() Hi I'm trying to run Plex on my Raspberry Pi 1st gen rev B, but it does not seem to be starting.
0 Comments
Leave a Reply. |